CNC painted and working great

Notice  the title didn’t say completely finished since the last few steps are to improve the acme screw feed as well as add a water table, ventilation system and wire up a better connector for the torch control.  But the paint looks great and the electrical components in a box is great.    The part you see cut is intended to be the plate that is the interface between the boiler and the burner.  I call it the burn plate.  It will go into the opening in the boiler, the holes in the very bottom will allow a resistance heater to light the biomass either pellets or chips, the holes above are for draft.  The large hole in the top center is for the auger feed and the remaining holes are on the left, a fire detector sensor and a hole to be tapped for attaching the sensor. The two holes in the upper right are intended to be the swivel point and observation port to observe the flame.    I drew the part that you see pictured up in Google Sketch Up.   What really impressed me about Sheetcam is that the piece to swing and hide the flame in the observation port was made at the same time from the scrap that was cut out of the auger hole.  Sheetcam automatically figured out the hole in this swinging part should be cut as a hole with the offset of the kerf to be on the inside of the hole, then cut the remaining profile as a outside kerf, then cut the auger hole as an inside hole.  This was all done in the correct order automatically.  Cool!   Sheetcam is a great program.

Cnc with cut Burner plate

Cnc with cut Burner plate

Cnc with cut Burner plate

Cnc with cut Burner plate



Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

w

Connecting to %s